Service 02 · Professional Engineering Services
Need it certified? We’re licensed to do that.
Independent review and certification of structural designs, shop drawings, and calculation reports by a professional engineer licensed across multiple states — including wind load calculations under ASCE 7-22.
Where we’re licensed
Active PE licensure
Working a project in a state your team isn’t licensed in? If it’s listed below, we can review and certify it.
Scope
What we review and certify
Structural documents across the full project lifecycle — from design through fabrication.
Wind load calculations
ASCE 7-22 wind load reports — including those produced in our calculator — reviewed and certified for permit submission.
Calculation reports
Structural calculation packages independently reviewed for method, assumptions, and code compliance, then certified.
Structural designs
Design drawings and documents reviewed against the governing building code and certified for submission.
Shop drawings
Fabrication and erection drawings reviewed for conformance with the design intent, then certified.
Out-of-state certification for firms
Extend your firm’s reach — independent review and certification under the appropriate state licence so you can take the project.
Peer review
Independent third-party review of another engineer’s design or analysis, with written findings.
How it works
Three steps
Send the documents
Email the drawings or calculations with the project state and your deadline. You get a fixed quote and turnaround before any work starts.
Engineering review
The submittal is reviewed against the governing code and edition for that jurisdiction. Anything unclear comes back to you as questions, not assumptions.
Certified and returned
You receive the certified documents as a PDF, ready for permit submission, along with any review comments.
Scope note. Professional engineering services are provided under a separate written agreement with defined scope and fee, and are distinct from any software subscription. The Wind Load Calculator is a calculation aid; using it does not engage AW Structural Services, LLC as engineer of record. Engagements are accepted only where the firm and engineer hold current licensure and any required certificate of authorization.